All units performance tested for proper operation, high/low speed output and voltage cutoff. All patterns oscilloscope tested.

CLICK HERE FOR
STARTER SPECS

All housings have mount surfaces and threads gauged & repaired as necessary

Fans straightened or replaced as needed

All pulleys painted, plated or dipped to inhibit corrosion

Shafts and threads gauged and replaced as necessary

Double sealed bearings used throughout

All bearing seats gauged and repaired as necessary

Rotors are tested for amperage and insulation quality

Stator is inspected for insulation quality, phase balance and rated output

Voltage regulator tested for voltage cutoff and output functions, replaced as necessary

New terminal hardware

High temperature insulators installed where required

All new brushes, springs gauged and replaced as necessary

Rectifier load tested, repaired or replaced

High capacity diodes and high temp solder used where required

Slip ring gauged and repaired as necessary, all are machined, polished and checked for "run out"

 

More detail?

PLEASE, USE THE MENU ON THE LEFT TO GET TO THE DESIRED PAGE.

PRECISION PARTS AND REMANUFACTURING
4411 S. W. 19TH OKLAHOMA CITY, OK 73108-1771  (405) 681-2592;  (800) 654-3846;  FAX (405) 681-2596